Operating Instructions
The load leveler is designed to handle and position components. The horizontal tilt can be adjusted to
compensate for off-center loads. It can also be used to angle a component when necessary to install it.
1. Hook the load leveler to a crane.
2. Attach the two load bearing chains to the component. Adjust the extension arms in or out to keep the chain
angle at a minimum. Make sure the bolts and nuts are tight before lifting a load.
3. Do not adjust the load leveler to an angle greater than 30°.
4. Do not spread the load bearing chains more than 90° for both chains.
5. Lift the component enough to determine the center of balance. Adjust the tilt screw with a wrench to adjust
the angle of the load by turning either end of the tilt screw.
30° Maximum
(Both Directions)
45°
Max.
45°
Max.
45°
Max.
45°
Max.
Figure 1
Figure 2
6
10262010
