HEIDENHAIN GAGE-CHEK 2000 Series, Operating Instructions Manual

Page: 68 / 236

Basic operation | Using the Inspector
6
6.11.1 Controls of the Inspector
The Inspector contains the following areas and controls:
Control Function
Quick access menu
The quick access menu displays the current settings:
Unit for linear values (Millimeters or Inch)
Unit for angular values (Radian, Decimal degrees, or
Deg-Min-Sec)
To adjust the settings of the quick access menu, tap the
quick access menu
Further information: "Adjusting settings in the quick
access menu", Page 71
6.11.2 Function elements
Function elements are operating elements that you can add to the Inspector and
configure individually.
The following function elements are available:
Function element Short description
Presets
Display of the current preset; tapping opens the preset
table
Further information: "Activating the preset", Page 158
Calculator
Tapping opens a calculator with basic mathematical
functions; the last result is shown in the calculator and the
Inspector
Reference mark search (REF)
Tapping starts the reference mark search
MinMax
Acquires the minimum, maximum, and range; tapping
starts the acquisition of measured values according to the
configuration
Further information: "Acquiring the minimum, maximum,
and range", Page 163
Manual output of measured values
Send measured values to computer; tapping starts the data
transfer according to the configuration
Further information:
"Sending measured values to a
computer", Page 164
Touch-probe triggered output of measured values
Send measured values to computer; tapping activates the
automatic output of measured values according to the
configuration; the data is transferred when the stylus is
deflected
Further information: "Sending measured values to a
computer", Page 164
68
HEIDENHAIN | GAGE-CHEK 2000 | Operating Instructions | 08/2020