HEIDENHAIN 548431-05, User Manual, Page: 554 / 722

Graphic simulation | 3-D simulation
7
554
HEIDENHAIN | MANUALplus 620 | User's Manual | 12/2017
7.10 3-D simulation
3-D simulation in Simulation submode
In the Simulation submode, you can test a program with the 3-D
simulation.
Activating 3-D simulation:
Select the 3-D simulation menu item
Deactivating 3-D simulation:
Select the
2-D simulation
menu item
The following functions are identical to 2-D simulation:
Using the simulation
Further information: "Using Simulation submode", Page 531
3-D view
Further information: "3-D view", Page 541
Mid-program startup
Further information: "Start block in smart.Turn programs",
Page 546
Time calculation
Further information:
"Time calculation", Page 548
Saving contours
Further information:
"Saving the contour", Page 549
Miscellaneous functions soft keys
Position a thread pattern on the surface
Display the workpiece edges
Switch to the next contour group
This soft key is only active if you are working
with multiple contour groups.
Display the tool holders
This function can only be used if values have been
specified in the optional
WHT and TOF parameters of
the tool holder function.
Further information:
"Holder editor", Page 571
Simulation of multiple contour groups
In 3-D simulation, only a single contour group is shown. If the
NC program includes multiple contour groups, you can use the soft
key to change between the contour groups.