HD15BT_01_EN
HD15BT - 15-Channel emitter with timer, white
Technical Data
• Battery 3 V, CR2430
• Frequency 433,92 MHz ± 100 KHz
• Ambient temperature: -20°C to 55°C
Notes
Attention!
Please carefully read the operating instructions of the emitter as well as the instructions of the tubular motor with built-in receiver / external receiver before commissioning and
observe ist instructions.
Important notes!
The emitters described are exclusively intended for the transmission of radio signals to our tubular motors and external receivers with radio code G2. Information on which
emiters have radio code G2 is available at www.heicko.de or www.heicko-bewegt.de.
The scope of this manual is limited to the description of the emitter as a control element. The description of the programming (“teaching“, etc.) with respect to the above
mentioned tubular motors with built-in receiver as well as the external receivers is given in the instructions for the tubular motors with built-in receiverse and external receivers.
• When the battery is almost empty, the symbol for the "low battery" appears on the display. Change the battery without pressing a button. The actual time remains without a
battery and is displayed for 15 seconds. If the battery change takes longer than 15 seconds, the display and the current time must be reset. After changing the battery, press
the up button once and the "low battery" symbol disappears.
• By pressing the up and down button simultaneously for 3 seconds the operation will be locked and the display shows "LOC". By the same procedure the operation can
be unlocked.
15-channel emitter HD15BT with timer
The button assignment for the general functions is shown in the figure at the to of this page.
The desired channel is selected with the channel selection buttons.
If channel 15 is active, pressing the right channel selection button again activates the group function. In the group function, all channels can be controlled simultaneously and
operated together by pressing the function buttons Up, Stop and Down.
User manual
User manual
User manual
QR-Code for
Radio code G2
-1-
Up
Stop
Down
Weekday
Channel
Display Time area
Display „weak battery“
Timer mode
Display „Down“
Display „Up“
12:00
Su
MAN
AUTO
1 .... 6 ........15
1
Back:
Battery compartment (without cover)
and function buttons.
Timer button
Mode selection
• The timer function is deactivated in manual mode.
• In automatic mode, the timer is activated and reacts at the set times.
• In random mode, the timer is activated and switches with a time delay of up to ± 15 minutes at the set times.
• To change the mode, press the mode selection button M for 3 seconds or keep it pressed to change continuously:
Press mode selection
button for 3 seconds
automatic mode
Press mode
selection button
for 3 seconds
random mode
manual mode
automatic mode
M
M
10:00
Su
AUTO
1
10:00
Su
AUTO
1
10:00
Su
MAN
1
10:00
Su
AUTO
1
Press mode
selection button
for 3 seconds
M
Press mode
selection button
for 3 seconds
M
• Transmission power: 10 mW
• Transmitter range: 100 m (outdoors)
35 m, through max. 2 walls
• If the transmitter range or signal strength decreases, a battery replacement is required.
• Moisture, excessive temperature, dust and force harms the device and can destroy it.
Mode selection
button M
Setup button
P2
Channel selection
Channel selection
button -
