6
Operating the P30A
The source and volume can be changed
using the input and volume selector on the
front panel or using the remote control.
Power Button
The P30A preamplifier can be switched on
and off with the power button located in the
middle of the front panel.
NOTE: When powering up, the P30A takes
about 60 seconds to calibrate, the outputs
are muted and the power light flashes to
indicate that mute is on. This is normal and
is part of the start-up procedure. When
the power light stops flashing the P30A is
ready to use.
NOTE: When the P30A has been switched
off, wait 30 seconds before powering it on
again.
Inputs
The P30A has both unbalanced (RCA) and
balanced (XLR) analog inputs. If you have
a source with fully balanced outputs, we
recommend using balanced cables to
connect the source to the P30A.
Outputs
The P30A has both unbalanced (RCA) and
balanced (XLR) analog outputs. If you have
a power amplifier with fully balanced inputs,
we recommend using balanced cables to
connect the P30A to the power amplifier.
Control Output
The control/trigger output uses a regular
3,5 mm jack plug. The control output will
function with most control/trigger inputs
(5-12V) from other manufacturers, but is
only guaranteed to work with HEGEL control
inputs.
IR Direct Input
This input can be used to connect to an
external IR receiver or home automation
system.
P30A
