Hegel H120, User Manual

Page: 10 / 20

10
General Use
Operating the H120
The source and volume can be changed
using the volume and input selector on the
front panel or using the remote control. The
volume level is indicated by a number be-
tween 0 and 99, with 0 being mute level and
99 being max volume. The H120 powers
up at a default volume 20. This value can be
changed, see Special Functions.
Power Button
The H120 amplifier is switched on and off
with the power button located on the under-
side of the amplifier, towards the front of
the unit. When powered up, the H120 takes
a few seconds to calibrate. During this time,
the outputs are muted.
NOTE: When powering up, the outputs are
muted and the volume flashes to indicate
that mute is on. This is normal, and is part
of the start-up procedure.
NOTE: When the H120 has been switched
off, wait 30 seconds before powering it on
again.
Headphone Output
Connect the 6.3mm headphone jack to
the front of the H120. This activates the
headphone volume control and mutes the
speaker outputs.
NOTE: Variable Line Output is still active.
Mute
Pressing the mute button on the Hegel
remote control mutes the outputs on the
amplifier. The volume flashes to
indicate that mute is on. Press the mute
button, or adjust the volume level, to switch
mute off.
Status Indicators
The Hegel H120 will display the network
status in the lower left corner.
Network status is OK:
Network status is
not OK: