HEEVE H0047, Instruction Manual

Page: 7 / 16

Positioning for Use
● Using the crank handle, raise the ramp to 100mm higher than the vehicle height or dock floor. Move
the vehicle into position very slowly and with adequate guidance from a spotter so the lip plate
overlaps the floor on the vehicle/dock. Lower the support legs to the needed height with the crank
handle to allow for needed support.
● NEVER USE THE RAMP WITHOUT THE SUPPORT LEGS IN PLACE. THIS IS DANGEROUS
AND CAN CAUSE SERIOUS INJURY OR DEATH.
● If your trailer is equipped with airbag suspension, release air before loading. Secure the ramp to the
trailer or dock with the attached safety chains. WARNING: Leave three chain links slack in the safety
chains. DO NOT attach too tightly.
In Use
● Vehicles traversing the yard ramp should always maintain a slow, steady, speed, preferably in low
gear. They should not stop or change gears while on the yard ramp as the increased traction will
cause excessive wear and damage to the vehicle tyres. Forklift trucks should ascend and descend
with their forks tilted back and raised enough to avoid contact with the yard ramp deck.
Removing from the In Use Position
● Disconnect the safety chains. Raise the ramp apron above the vehicle floor level. Move the vehicle
away from the ramp.
8. MAINTENANCE
● Inspect all components regularly including inspection of the frame structure weld joints, deformation,
wheel bearings, paint protection, lifting points, fixing chains and all moving parts. Do not use the
ramp if there are any faults found during inspections. We recommend that you record the results of
the inspections in an inspection book.
Page 7
HEEVE COMMERCIAL SERIES YARD RAMP INSTRUCTION MANUAL
© 2022 Heeve | www.heeve.com.au