HEC HEC12EFM Series, Service Manual

Page: 6 / 17

Version:00.00 Edition: 2008-04
Dishwasher
Model:HEC12EFM/HEC12EFMS
6/17
tightly in place (see Fig 1).
If the water pipes are new or have not been used for an extended period of time, let the water run to make
sure that the water is clear and free of impurities .If this precaution is not taken, there is a risk that the
water inlet can get blocked and damage the appliance.
4.4 Hot Water Connection
The water supply to the appliance can also be connected to the house's hot water line (centralised
system,heating system),as long as it does not exceed a temperature of 60
℃
.
In this case,the wash cycle time will be shortened by about 15 minutes and the wash efficiency slightly
reduced.
The connection must be made to the hot water line following the same procedures as those for the
connection to the cold water line.
4.5 Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter of 4cm,or let it run into the sink, making
sure to avoid bending or crimping it. Use the special plastic support that comes with the appliance (see
Fig.2). The free end of the hose must be at a height between 40 and 100 cm and must not be immersed in
wate
r.
4.6 Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to those
on the rating plate (located on the stainless steel inner door of the appliance) and that the electrical system is
correct for the maximum voltage on the rating plate, insert the plug into an electrical socket which is earthed
properly (the earthing of the appliance is a safety requirement mandated by law).
If the electrical socket to which the appliance must be connected is not appropriate for the plug, replace the
plug rather than using adpators or the like as they could cause overheating and burns.