HEBU medical HB 8881, Operating And Service Manual, Page: 22 / 82

HEBU Vacuum Cleaner
22
EN
Commissioning:
➢
Adapt the suction hose
➢
Connect the mains plug.
➢
Switch on the device and start up
4.2 Automatic mode
➢
Insert the mains plug of the
HEBU oscillating saw at the
vacuum cleaner (1).
➢
Switch on the vacuum cleaner (2).
➢
The lamp lights up and the vacuum cleaner
runs for around 0.5 seconds
as a function check. The vacuum cleaner
then goes to the standby mode (3)
Note:
♦
The vacuum cleaner is automatically switched on and off in the standby mode by the HEBU
oscillating saw, provided you have performed the following points beforehand:
- Every time the vacuum cleaner is first switched on, it goes to the standby mode.
- or after being switched on again at least 6 secs. after last being switched off.
♦
The vacuum cleaner has a run-on time of up to 6 secs. This is intended to ensure that the vacuum
cleaner hose is completely emptied.
♦
If the vacuum cleaner is switched on again less than 4 seconds after being switched off,
the suction process operates without automatic function. However the HEBU oscillating saw
can still be switched on and off.
♦
The voltage specification of the vacuum cleaner must agree with the voltage specification
of the HEBU oscillating saw.
2
1 3