HEBU medical GOLD II Accu, Operating And Service Manual

Page: 19 / 71

Oszillosäge GOLD II Accu
19
EN
T
h
e
el
e
ct
ro
ni
cs automatically switch off the motor prior to the battery being deep discharged. Operate and
charge the battery only within the
battery operating-temperature range of 0 °C
– 45 °C (32 °F –
113 °F) . At the beginning of the charging procedure, the battery temperature must be within the
battery operating- temperature range.
5 Mounting / exchanging the saw blade
!
Danger of injury when unintentionally turned on. Remove
accumulator before changing. Should it be necessary, use stable
gloves so that you Can not be injured by the saw blades. Only
connect the accumulator when the saw is switched off.
5.1 Releasing the retaining screw / removing the old saw blade
1. Place the cast cutting saw on a stable underlay (table).
2. Apply one fork wrench at the drive shaft behind the saw blade, and the other one at the front at the
retaining screw (see
fig. 3
).
3. Hold the rear wrench firmly and use it to fix the cast cutting saw.
4. Release the retaining screw using the front wrench.
5. Remove the retaining screw and the fixing ring. Ensure that you do not lose any components.
6. If applicable, remove the old saw blade.
fig. 3 Releasing the retaining screw
1
– 4 green LED
Percentage of charge condition Operation
Continuous red light Battery is almost empty Charge battery
Red flashing light
Battery is not ready for
operation
Bring the battery into the battery
operatingtemperature range, then
charge