Table Layout
The approximate number of heaters required to heat a common residential table setting is given below.
1x TG2200RB
2x TG2200RB
Safety
The TG2200RB has an IP rating of X4. This means it is protected against water splashed from all directions but
limited water ingress is permitted.
The TG2200RB has undergone extensive testing both in laboratory conditions, in Thermofilm
’
s manufacturing
facility and field trials in Australia and overseas. It is this testing that gives the purchaser the confidence
of a high quality product.
Independent laboratory testing has confirmed Thermofilm
’
s full compliance with Australian and New Zealand
standards.
TG2200RB is Class 1 equipment and must be earthed.
In operation, this heater is VERY HOT—
do not touch any part of the heater while it is turned on. Do not touch any
part until 30 minutes after it is turned off.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or intellectual
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure
they do not play with the appliance.
Do not allow any cables, furnishings, flammable materials or other items come in contact with any surface of the
heater.
If installed in wet areas, the heater switches or controls must be located so that they cannot be touched by
persons in the bath or shower.
The heater needs to be installed as per the installation instructions paying special attention to the minimum
clearances. The heater needs to be mounted on a rigid bracket or fixing.
The heater must not be mounted immediately below or in front of a socket outlet.
