Operation
Press
“
On/Off
”
button to turn power on and off.
Once turned on, the controller will default to High power setting and will be permanently on (no
timer function). Press
“
POWER
”
button to select the desired power setting by cycling through
HIGH—MEDIUM
-
LOW. When power setting is at high the controller will provide continuous
power. When power setting is at
“
MEDIUM
”
or
“
LOW
”
the output alternates between being on
and off so that it delivers a lower output to the heater. Press
“
TIMER
”
button to set the timer to
1,2,4 hours or permanently on. When permanently on, one of the TIMER LED
’
s will be illuminat-
ed. Once the timer is selected, the timer will be started immediately. When the timer has end-
ed, power will turn off and all LED
’
s will also turn off.
Thermal Cut
-
Out Protection
This controller is protected by a thermal cut
-
out switch. This switch is activated when the
temperature of the controller is too high. The controller will cut all power until it has sufficiently
cooled. Once it cools the unit will continue working as usual.
Warm Up Mode
The controller is programmed to operate continuously (High setting) for the first 15 minutes of
operation regarding less of the selected power setting, this is to allow time for the heater to
warm up. After this time it will operate as selected.
Safety
The TT
-
MTM controller is to be mounted indoors it needs to be away from wet conditions.
Ensure the connections are properly connected. The controller needs to be installed according
to your local wiring guidelines and regulations . Do not allow any cables, furnishings, flammable
materials or other items to obstruct the vents of the controller. Never block the air vents of the
controller.
Never block the air vents of the controller. Do not put anything in the vents of the controller.
The appliance is not intended for use by persons (Including children) with reduced physical,
sensory or intellectual capabilities, or lack of experience and knowledge , unless they have been
given supervision or instruction concerning use of the appliance by person responsible for their
safety. Children should be supervised to ensure they do not play with the appliance.
Maintenance
The TT
-
MTM Controller is made from durable materials, however regular care and maintenance
of your controller will help prolong the life of the product. It is recommended that you dust the
controller to keep the surface clean. Cleaning at least every three months will reduce the
amount of dust build up and keep it looking at its best. Do not use any abrasive materials or
product s to clean the controller, this includes solvents, citrus based cleaners or other harsh
cleaning products. Do not use water or a damp cloth to clean the controller. The remote uses a
CR2025 3V lithium battery. If the red light on the remote stops working then change the battery.
