14
10.0 USER INSTRUCTIONS
10.1 Once installed the filling and the heating cycles of the Heatstore Ultima
Profile Eco are completely automatic.
10.2 To dispense water, place a suitable container under the outlet spout and pull
the tap handle down and towards (or pushed away) the user. The water
dispensed will at all times be boiling or close to boiling point so due caution
must be taken when using the product.
10.3 The tap handle is spring loaded so that when released it will spring back
to the “off” position (no flow).
10.4 The Heatstore Ultima Profile Eco is fitted with two neon indicators. The
upper red neon indicates POWER ON. The lower green neon indicates
TEMPERATURE READY. When the green neon is flashing, the unit is
commissioning (DO NOT draw water off). When the green neon is on and
stays as a solid light, the unit is ready to be used.
10.5 If the store of hot water is completely withdrawn, the flow rate from the outlet
tap will reduce to the filling rate of the heater (leave for 2 minutes before
drawing any more water off). This slow flow rate allows the incoming water
to be instantly reheated, it does not indicate a fault with the water heater.
10.6 If the unit is not used for a few days the water may become “stale”. In these
instances it is advisable to draw off the contents and discard the water at least
twice to remove the “stale” water. This will ensure that “freshly” boiled
water is used to make your drinks etc.
10.7 Similarly, if left unused it is possible that some scale residue will collect in
the outlet tap. This will cause the outlet water to appear “milky” for a short
while. If this condition occurs it is recommended that the first few cups are
drawn off and discarded.
