Use the top left hand switch to select
AUTO
or
OVERRIDE
.
• Setting
AUTO
provides hot blowing when the
ambient temperature is below 23°C – above 23°C it
blows cool.
• Setting
OVERRIDE
provides hot blowing at all
times when the right hand switch is set to hot.
When you have the desired setting, make sure the
POWER
is set to on
Operation
This unit is easy to use. It starts and stops automatically
when your hands are inserted into and removed from
the unit. During operation the LED in the centre of the
control panel will show activity and count down from
10 seconds to zero during the drying process –
see
figure 8
.
When idle the LED displays the ambient temperature.
Drying your hands
Shake off excess water before inserting your hands into
the unit.
Step 1
Insert your hands into the unit with your fingers slightly spread. The hand
dryer will start automatically as you do this –
figure 7a, Step 1.
Step 2
Slowly withdraw your spread fingers; you will feel the powerful air flow
pressing against your hands as you do this
– figure 7b, Step 2
.
Step
3
If your hands still feel wet repeat the first two steps
– figure 7c, Step 3
.
5
Fig 7a:
Step 1
Fig 7b:
Step 2
Figure 6a: Cool blowing
over 23°C ambient
Figure 8: countdown on
the LED, 10-0 seconds
Fig 7c:
Step 3
HS5810_instructions 19/4/13 08:47 Page 5