background image

 

 

58000305 Iss 1 

 

CONNECTION TO THE MAIN SUPPLY 

 

Electrical installation should be carried out by a competent installer, preferably registered with 

NICEIC (National Inspection Council for Electrical Installation Contracting) in accordance with the 
16 edition of the IEE Wiring Regulations, (BS.7671: 1992), and any relevant Local Authority Bye-

Laws. 
 

This heater is fitted with a 3-core mains supply cable and should be permanently connected to 

the electricity supply via a double pole switch having 3mm gap on each pole. 
  A switched Fused Connection unit to BS.1363. Part 4 is a recommended mains supply 

connection accessory to ensure compliance with safety requirements applicable to a fixed-wiring 
installation. 

 

MAINTENANCE 

 

ALWAYS ENSURE THAT THE MAIN EXTERNAL ELECTRICAL SUPPLY IS SWITCHED OFF BEFORE ANY 

MAINTENANCE IS CARRIED OUT. 
 

 

To obtain the best results from the heater, it is necessary to avoid any accumulation of dust or 

dirt within the unit or on the air inlet grille.  The unit should be cleaned regularly.

 

 

PROTECTION (Thermal Cut-out) 

 

The units are protected from overheating in the event of fan failure, or an obstruction of the 

free airflow, by an auto reset thermal cut-out.  If this happens the thermal cut-out effectively 

switches the appliance off. The appliance will not operate until it has cooled down. If this fault re-
occurs, refer to ‘fault conditions’.  

 

FAULT CONDITIONS 

  If the heater will not operate, disconnect it from the mains and arrange for a certified 

electrician to attend to investigate the reason. 

 

SAFETY 

  This equipment has been designed and manufactured to the highest international standards 

but, like all electrical appliances which are operated by mains voltage, care must be taken if you 
are to obtain the best results and safety is to be assured. 

ƒ

 

Do NOT use this appliance in bathrooms or where similar conditions of excessive moisture are 
present. 

ƒ

 

No NOT handle the appliance with wet hands. 

ƒ

 

Do NOT use the appliance in an enclosed room so small that the heater will generate ambient 

temperatures in excess of 30

0

C. 

ƒ

 

Do NOT use the appliance with young children unattended. 

ƒ

 

Do NOT use the appliance in rooms where excessive dust is generated or present. 

ƒ

 

Do NOT touch THE outlet grille when appliance is in use. 

ƒ

 

Do NOT cover or restrict any aperture of the appliance when in use. 

ƒ

 

Do NOT use the appliance if damaged. 

 

  If the appliance has been kept in freezing conditions, run at cold/fan setting for 5 minutes 
before using heat settings. 

 

 

This appliance meets the requirements of EU Directive 98/336/EEC for EMC. 

 

Avon Riverside, Victoria Road, Avonmouth, Bristol  BS11 9DB 

Telephone: 

0117 923 5375   Fax:  0117 923 5374

 

Avon Riverside, Victoria Road, Avonmouth, Bristol BS11 9DB 

Telephone:  0117 923 5375 

Fax:  0117 923 5374 

 
 

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS FOR 

 

 

WALL MOUNTED FAN HEATER 

 
 

Catalogue Numbers: 

HSCPF3000/HSCPF3000T (painted steel fascia) 

 

HSCPF3000BA/HSCPFT3000BA (brushed aluminium fascia) 

 
 

PLEASE RETAIN THIS LEAFLET FOR FUTURE MAINTENANCE

 

 
 
 

 

 
 

Reviews: