On the RF-Switch, press and hold the CH1 pairing button for 5 seconds.
The CH1 status LED will start to flash.
Press and release the pairing button on the UH8-RF.
When the RF-Switch detects the pairing signal from the UH8-RF, the CH1 LED
will stop flashing.
To pair your wireless thermostat to the RF-Switch, please refer to your wireless
thermostat instruction manual.
When pairing a thermostat in combined heating/hotwater mode, you do not
need to pair to the HW channel. This is done automatically when the stat is
paired to either CH1 or CH2.
RF-Switch Wiring Diagram (S Plan)
6
Pairing the RF-Switch to the UH8-RF/UH8-RF V2
Channel Reset
4
5
To reset an output of the RF-Switch;
•
Press and hold the pairing/override button of the desired channel for 15 seconds.
During the button press you will see the LED flash steadily followed by a rapid flash.
Once the LED has stopped blinking, the reset procedure is complete and will erase all
devices paired to that channel..
ZONE 1
HEATING VALVE
HOT WATER
VALVE
C1
NO1
C2
NO2
C3
NC3 NO3
N EARTH
L
MAINS
SUPPLY
230v
L
E
N
BOILER AND
PUMP ENABLE
HOT WATER
STAT
HW
CH1
CH2
ZONE 2
HEATING VALVE
This product must only be installed by a qualified
electrician and comply with local installation regulations.
•
•
