background image

• Heatmaster/American Gas Log,  Outdoor Burner/Hearth Kits •IM-116. Rev G . 01/2019

7

Operating Instructions 

A. Lighting Instructions

WARNING: IF THESE INSTRUCTIONS ARE NOT FOLLOWED EXACTLY, A FIRE OR 

EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR 

LOSS 

OF 

LIFE. 

        

A.  This appliance has a pilot that must be lighted by hand. When lighting the pilot, follow these 
 

 

 

 

 

 

instructions 

exactly.           

B.  BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next  to the floor 

      because some gas is heavier than air and will settle on the floor.  

 

    

 

 

     WHAT TO DO IF YOU SMELL GAS 

 

 

 

 

 

 

 

 

 

 

Do 

not 

try 

to 

light 

any 

appliance. 

        

         Do not touch any electrical switch: do not use any phone in your building.   

 

 

         Immediately call your gas supplier from a neighbor’s phone. Follow gas supplier’s   

 

 

 

 

 

 

 

 

 

instructions. 

           

   

If you cannot reach your gas supplier, call the fire department. 

 

 

 

 

C.   Use only your hand to push in or turn the gas control handle. Never use tools. If the   

 

      handle will not push in or turn by hand, do not try to repair it. Call a qualified service    

 

   technician. Force or attempted repair may result in fire or explosion. 

 

 

 

 

D.   Do no use this appliance if any part has been under water. Immediately call a qualified  service    

       technician to inspect the appliance and to replace any part of the control system and any part of   

       the gas control that has been under water. 

 

 

 

 

1.  STOP! Read the safety information listed above.
2.  Turn gas control handle clockwise     to the “OFF” position. 

 

 

 

 

 

3.  Wait 5 minutes to clear out any gas. Then smell for gas, including near the floor. If you smell    

     gas, STOP!. Follow “B” in the safety information above. If you do not smell gas go on to next step. 

4.  Locate pilot (mounted on the right side of the top burner pan).   

 

 

 

 

5.  Turn control handle counterclockwise    to the “PILOT” position. 

 

 

 

 

6.  Place a lit match at the pilot burner and simultaneously push in on the control handle.     

 

     This should ignite the pilot.  

 

 

 

 

 

 

 

 

 

7.  Once the pilot lights, continue to depress the control handle for 1 minute. 

 

 

 

8.  After 1 minute slowly release control handle and it will pop back out. Pilot should remain lit. 

 

     If it goes out, repeat steps 1 through 7. 

 

 

 

 

 

 

 

 

     If the handle does not pop out when released, stop immediately and call your   

 

 

     service technician or gas supplier.  

 

 

 

 

 

 

 

 

  If the pilot will not stay lit after several tries, turn the gas control handle to the “OFF”   

 

  position and call your service technician or gas supplier.  

 

 

 

 

 

9.  Turn gas control handle counterclockwise   to the “ON” position. 

 

   

FOR YOUR SAFETY READ BEFORE LIGHTING

                 LIGHTING INSTRUCTIONS

        TO TURN GAS OFF TO APPLIANCE

Turn gas control handle clockwise   to the “OFF” position. Do not force.

Summary of Contents for DG-SS 30LP













Reviews: