1. INTRODUCTION
Heatit WiFi thermostat is an electronic thermostat for electrical
underfloor heating. The thermostat has a simple user interface and
can be easily programmed via the capacitive buttons. The color screen
displays an accessible user interface. The thermostat has a built-in WiFi
chip that allows you to control it from a user-friendly app. The ”Heatit
WiFi” app is available on Google Play and in the App Store. Works
with Amazon Alexa and Google Home (pending). If you are installing
multiple thermostats in the same house, you may copy the settings
from one thermostat to the next. This simplifies installation.
Heatit WiFi thermostat 16A is equipped with a single-pole switch and
fits into most common frames (e.g. System 55, Elko RS16, Schneider
Exxact). The thermostat can withstand a load of max 16A/3600W
at 230VAC. We recommend a contactor for loads above 13A. The
thermostat may be connected to an external sensor.
The thermostat is designed for electrical heating.
2. INSTALLATION
Installation must be done by a qualified electrician in accordance with
the national building codes. Before installation, disconnect any power
to the device mains. During installation of the device, power to the
device must be disconnected AT ALL TIMES!
Release the front cover by pressing e.g. a screwdriver gently into the
ejector latch at the bottom of the thermostat.
Now connect the wires to the thermostat terminals:
L
Power connection (Live)
LOAD (N)
Heating Cable connection (Neutral)
LOAD (L)
Heating Cable connection (Live)
N
Power connection (Neutral)
PILOT
Pilot Wire (if applicable)
SENSOR
Floor temp sensor, NTC type
TABLE OF CONTENTS
1.
Introduction
2.
Installation
3.
Startup
4.
Symbols
4.1
Operation mode
4.2
Heating/Cooling active
4.3
Note
5.
Controls
6.
Standby and main screen
7.
Menu items
8.
Operation mode
9.
Weekly schedule
10.
Heatit WiFi zones
11.
Advanced settings
12.
WiFi settings
13.
Phone applications
14.
Product info
HEATIT WIFI
Installers manual
Ver 2021-A
01.10.2021
