09/04
30484 Rev Q
35
MAXUS DIRECT VENT HEATER
4. Clean the Glass
The glass panel and its gasket must be inspected at least once a year. See Figure 53 for glass panel removal
instructions.
a.
Carefully inspect the fixed glass door gasket to make certain it is sealing properly. Check for worn spots and/or
where the gasket may have come loose from the frame. Replace the gasket if it is worn or has come loose from
the frame.
b.
Clean the glass (only when cool!) with a nonabrasive cleaner such as Brasso®.
c.
Never operate this appliance without the glass properly secured in place or if the glass is broken.
d.
In the event of glass breakage, carefully remove the glass frame. This will allow the removal of all glass
fragments and sheet metal edge protection strips. Vacuum all remaining glass pieces with a shop vac.
Do not
vacuum if the pieces are hot!
Replace the glass only with a Heatilator glass panel assembly ordered through
your local distributor. Never use substitute material. Only ceramic glass may be used on this appliance.
Figure 53 - Glass Cleaning
Figure 54 - Log Removal
5. Log Removal/Replacement
a.
Removal
If removal of the logs becomes necessary, remove
the two screws (one at each end of the grate).
Grasp the grate and lift the logs up off the burner
and pull the entire assembly out of the appliance.
See Figure 54.
b.
Replacement
To replace the logs, grasp the grate as shown.
Lower the log set onto the burner pan. Situate the
logs by placing the tabs (from which the two
screws were previously removed) over the
matching holes in the hearth floor. Reinstall the
two screws (one on each side of the grate) to
secure in place.