15
Heatilator • ION-V7, ION-S7, ION-H7 Owner’s Manual • 2276-981 Rev. E • 5/17
Remote Control
Frequency:
Seasonally
By:
Homeowner
Tools needed:
Replacement batteries and remote con-
trol instructions.
• Locate remote control transmitter and receiver.
• Verify operation of remote. Refer to remote control
operation instructions for proper calibration and setup
procedure.
• Place batteries as needed in remote transmitters and
battery-powered receivers.
• Place remote control out of reach of children.
If not using your
fi
replace for an extended period of time
(summer months, vacations/trips, etc), to prevent unin-
tended operation:
• Remove batteries from remote controls.
• Unplug 6 volt adapter plug on IPI models and/or remove
batteries from battery pack.
Venting
Frequency:
Seasonally
By:
Homeowner
Tools needed:
Protective gloves and safety glasses.
• Inspect venting and termination cap for blockage or
obstruction such plants, bird nests, leaves, snow, debris,
etc.
• Verify termination cap clearance to subsequent construc-
tion (building additions, decks, fences, or sheds).
• Inspect for corrosion or separation.
• Verify weather stripping, sealing and
fl
ashing remains
intact.
• Inspect draft shield to verify it is not damaged or missing.
GLASS ASSEMBLY
GLASS LATCHES
(BOTH TOP AND BOTTOM)
Figure 4.1 Fixed Glass Assembly
Doors, Surrounds, Fronts
Frequency:
Annually
By:
Homeowner
Tools needed
: Protective gloves, stable work surface
CAUTION! Risk of Injury!
Decorative front is heavy.
Handle with care.
Remove
decorative front from appliance by carefully lift-
ing the front up and off the four shoulder bolts on the ap-
pliance. Refer to decorative front instructions for more
detailed information.
• Assess condition of screen and replace as necessary.
• Inspect for scratches, dents or other damage and repair
as necessary.
•
Check that louvers are not blocked.
•
Vacuum and dust surfaces.
Replace decorative front by mating the four hooks on
the decorative front with the four shoulder bolts on the
appliance. Place the front on the two bottom hooks and
then tilt inward and onto the top two hooks.
