7057-143A • 20 August, 2018
Heatilator EcoChoice WS22
23
www.heatilator.com
1.
Install washer on door handle shaft.
2.
Slide door handle through door.
3.
Install second washer(s) as shown in
Figure 23.1
.
4.
Install key in groove.
5.
Align groove in latch cam with key; slide latch cam over
shaft
6.
Install locknut but do not overtighten, the handle needs
to move smoothly.
7.
Install spring handle turning in a counter-clockwise
motion to desired location on door handle rod.
Figure 23.1
Locknut
Door Cross Section
(example)
Latch Cam
Spacing
Washers
Square Key
Door Handle
Spring
Handle
C. Door Handle Assembly
CAUTION!
Do not over tighten lock nut. The door handle needs to
move smoothly.
Figure 23.2
2 pc Baffle Board
Tube Channels
Baffle
Protection
Channel
Ceramic Blanket on Top
Burn Rate
Air Control
Baffle Boards & Blanket
even with front tube and
resting on back tube
Figure 22.1 - Baffle
1.
Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2.
Remove the baffle prote
ction channel by rotating it
down from the front tube (Figure 22.2)
.
3.
The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other
one and pull out top piece through the door opening
and then remove bottom baffle piece
(Figure 22.1)
.
4.
Remove the ceramic blanket.
5.
Re-install the ceramic blanket and smooth out the
blanket.
6.
Slide the baffle pieces one piece at a time underneath
the blanket. Be sure the baffle boards are even with the
front manifold tube and is resting on all tubes
(Figure
22.1 and 22.2)
.
7.
Re-install the baffle protection channel by rotating it
up and around the front tube so the bottom flange of
the channel rests behind the manifold tube. The baffle
boards and blanket are tucked inside the rear of the
baffle protection channel.
D. Baffle Removal
