-2-
598-1172-03
5. Mount push button. Use either screws or double sided tape to mount push
button.
• To mount with screws, remove back of case by pushing in tab on bottom
with a small screwdriver. Attach back of case to door jamb or wall. Snap
front of push button on.
• When attaching push button using double sided tape, make sure the surface
of the door jamb or wall is clean.
6. Determine cover mounting type. The cover supplied with the chime base
will either snap onto the base or hang from a cover pin.
•
Snap-On Cover: Apply pressure to the cover until it snaps into place (see
Figure 6). To remove, firmly grasp cover and pull to remove from base.
•
Hanging Cover: Before mounting chime base to wall, slide the cover pin
that will be on top of the mounted base out of the base. Turn it over so the
pin is protruding above the base. Slide the cover pin into base (see Figure
7). Hang cover on cover pin.
Note:
Cover pins are located on two sides of the chime base for use with hanging covers. When
chime base is mounted according to mounting orientation marking, use the cover pin located
on the top of the chime base for hanging the cover.
TYPE
‘D
’
LR20
TYPE
‘D
’
LR20
TR
-0035-R
X
TR-0095-RX
TYPE
C
Cover Pin
Chime Base
Figure 6
Snap-On
Cover
Mounted
Chime Base
Figure 7
Figure 5