INSTALLATION AND OPERATION
PICTORIAL 2-1
Refer to Pictorial 2-1 for the following steps.
( ) Make sure the POWER switch (on the rear panel
of your Computer] is in the OFF position.
( ] Unplug the Computer’s line cord.
( ) If this has not already been done, remove the
two screws that hold the top cover on the Com
puter. Then remove the cover.
NOTE: You may wish to set the switches on the Ex
tended Configuration Board before you install it in
your Computer. Refer to the information in the
“Status Port” section, which follows.
( ) Position the Extended Configuration Board in
side the chassis as shown. (NOTE: You must
install this circuit board with the components
toward the rear panel.) Then carefully push the
connectors on this circuit board onto the plugs
at P10 on the mother circuit board.
NOTE: The blue and white label shows the Model
Number and Production Series Number of your kit. Be
sure to refer to these numbers in any communications
you have with the Heath Company about your kit.
This assures you that you will receive the most com
plete and up-to-date information in return.
( ) Carefully peel the backing paper from the blue
and white label. Then press the label onto the
rear panel of the Computer in a clear area.
