15
Figure 5.
Vent System Components and Termination Kits
Step 3. Installing the Vent System
A. Vent System Approvals
These models are approved to use PVFLEX series vent
pipe components and terminations (see Figure 5). Ap-
proved vent system components are labeled for identifi-
cation. This pipe is tested and listed as an approved com-
ponent of the fireplace. The pipe is tested to be run inside
an enclosed wall. There is no requirement for inspection
openings at each joint within the wall. There is no required
pitch for horizontal vent runs.
NO OTHER VENTING SYS-
TEMS OR COMPONENTS MAY BE USED
.
Detailed installation instructions are included with each vent
termination kit and should be used in conjunction with this
Installers Guide
.
The flame and ember appearance may vary based on the
type of fuel burned and the venting configuration used.
90 DEGREE
BEND
LISTED VERTICAL
B-TYPE TERMINATION
STORM
COLLAR
ROOF
FLASHING
LISTED
SINGLE WALL
B-VENT
PV-VERT
INSIDE WALL OR
CEILING FIRESTOP
PV-HORZ
PV-FS
FIRESTOP
PV-FLEX-10
PV-FLEX-25
25’ Length of Flex Pipe
10’ Length of Flex Pipe
PV-HORZ
PV-VERT
TERMINATION KITS
PV-WIRE
PVWIRE-10 .....10 feet, 5 wire harness
PVWIRE-40 .....40 feet, 5 wire harness
PVWIRE-80 .....80 feet, 5 wire harness
PVFLEX-CONNECT
