9
Heat Controller, Inc.
VCH SerieS
Owner’s Manual
Keep the remote controller where its
signals can reach the receiver of the
indoor unit. (a distance
with 25 ft (8m)
is
recommended
).
When you select the timer operation, the
remote controller automatically transmits
a signal to the indoor unit at the specified
time.
If you keep the remote controller in a
position that hinders proper signal
transmission, a time lag of up to 15
minutes
may occur.
Location of the remote controller.
.
.
8m
The air conditioner will not operate if curtains, doors or other materials
block the signals from the remote controller to the indoor unit.
Prevent any liquid from falling into the remote controller. Do not expose
the remote controller to direct sunlight or heat.
If the infrared signal receiver on the indoor unit is exposed to direct
sunlight, the air conditioner may not function properly. Use curtains to
prevent the sunlight from falling on the receiver.
If other electrical appliances react to the remote controller. either move
these appliances or consult your local dealer.
.
.
TEMP
CLOCK
SPEE
D
MODE
FA
N
SP
EED
ON
OFF
TE
MP
C
4
The remote controller uses two alkaline
AAA
dry
batteries (R03/LR03X2)
(1) Slide the cover of the battery
compartment
out all the way until the battery
compartment is revealed
, then replace the old
batteries with new ones.
(2) After step (1) is done, push the RESET
button.
(3) Before replacing the battery compartment
cover, confirm that the display screen on
the remote controller displays "0:00" and
that the colon is flashing.
After replacing batteries,
re
set the remote
controller clock.
Replacing batteries
AUTO COOL DRY
HEAT FAN
TEMP
CLOCK
TIMER ON
TIMER OFF
SPEED
AUTO LOW MED HIGH
MODE
ON
OFF
TEMP
FAN
SPEED
AIR
DIRECTION
SWING
CLOCK
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
TIME ADJUST
OK
CANCEL
.
AUTO COOL DRY HEAT FAN
TEMP
CLOCK
TIMER ON
TIMER OFF
SPEED AUTO LOW MED HIGH
MODE
ON
OFF
TEMP.
FAN
SPEED
AIR
DIRECTION
SWING
CLOCK
ECONOMIC
RUNNING
TIMER ON
TIMER OFF
TIME ADJUST
OK
CANCEL
The OPERATION lamp on the display
panel
of the indoor unit starts flashing.
1. Mode select button (MODE)
Select AUTO.
2. Temperature button (TEMP.)
Set the desired temperature. Normally,
it is
O
O
O
set
between
70 F
/
21 C t o
84
F
/
2
8
C
3. ON/OFF button
Push this button to start the air conditioner.
The OPERATION lamp on the display
panel of the indoor unit lights. The
operating mode is selected in accordance
with the room temperature and operation
starts after approximately 3 minutes.
O
ON/OFF button
Push this button again to stop the air
conditioner.
If the AUTO mode is uncomfortable, you
can select the desired conditions manually.
When you select the AUTO mode, you do
not have to set the fan speed. The FAN
speed display will show AUTO and the fan
speed will be automatically controlled.
When you set the air conditioner in AUTO
mode, it will automatically select cooling,
heating
or
fan only operation depending
on the room
temperature.
Once you select the operating mode, the
operating conditions are saved in the
unit's microcomputer memory.
Thereafter, the air conditioner will start
operating under the same conditions
when you simply push the ON/OFF
button of the remote controller.
Start
Stop
2
3
1
7
.
.
F
F
AUTOMATIC OPERATION
HANDLING THE REMOTE CONTROLLER
CAUTIONS
