6
Heat & Glo • LOGS-2531, LOGS-2532, LOGS-2533 Installation Instructions • 2532-935 Rev. C • 3/19
Figure 23. Log #5 Installed
LOG #5:
The non-burnout end of Log #5 will sit on the flat spot of Log #3. The corner of the other end will sit on the base
refractory grout line. See Figure 23.
3
5
Figure 22. Log #4 Installed
2
1
4
LOG #4:
Set the non-Y end of log 4 on the flat spot of Log #1. The end of Log #4 will sit flush with the back of Log #1. The
Y-end of Log #4 will sit on the flat spot of Log #2. See Figure 22.
LOG #3:
With the burnout facing left, place the big end of Log #3 against log pin F and slide back until it contacts log pin G
as shown in Figure 21. The small end will sit on the flat spot of Log #2.
Figure 21. Log #3 Installed
2
3
F
G
Figure 24. Log #6 Installed
3
5
H
Figure 25. Log #6 Installed
3
6
H
LOG #6:
Slide the burn out end of Log #6 between log #5 and log #3. Push the log back until it touches the firebox. The
left side will touch pin H. The right side of the log touches Log #3. See Figures 24 and 25.
5
6