i30-X Linear and stretch base
Assembly instructions
Step1.
Unbox the base and identify each component
using the table on page 3.
Step 2.
Locate and position the top panel on a clean
and flat surface upside down.
The side panels are attached using the supplied
nuts (x6) which are fixed to captive welded bolts
on the inside of the top panel.
Step 3.
Identify the left and right side panels. Each side
panel will have a larger return on the front side
and bolt holes that line up to the top panel
captive bolts.
Fit the side panels one at a time by positioning
them onto the top panel first and sliding on to
the captive bolts. Then tighten the nuts as
shown.
Step 4.
Locate and position the rear panel.
The panel will fit between the base vertical return
and is fixed in place using the supplied black
screws
NOTE: A PH1 size bit is best suited to the screw
head size.
Step 5.
Locate and secure the base panel with the
supplied screws.
Once the base is secured, flip the base back
over to begin assembly of the case.
Page 4