1
Heat & Glo • GLASS-5/7/9, GLASS-3X/5X/7X/9X Installation Instructions • 2372-951 Rev. F • 11/18
TOOLS
Screw gun equipped with 1/4 in (6 mm). socket or
1/4 in. (6 mm). wrench or socket
KIT COMPONENTS
(1) Left Glass Panel
(1) Right Glass Panel
(1) Rear Glass Panel
(2) Lower Glass Brackets (1 left, 1 right)
(1) Rear Lower Glass Bracket
(2) Upper Glass Brackets (1 left, 1 right)
(2) 3/8 in. (9.5 mm) Sleeves
(4) 1/2 in. (13 mm) self-tapping Screws
(2) 1-1/4 in. (32 mm) screws
(1) Top Refractory Panel (SL-X series only)
Leave this manual with party responsible for use
and operation.
Installation Instructions
1. Remove existing brick kit liner and logs from appliance,
if installed. The SL-X series ships standard with a four
piece refractory kit.
2.
All Models:
Remove the screw that secures the pilot assembly to
the pilot bracket and gently pull the pilot upward about 2
inches (51 mm).
3.
SL-X Series with Standard Refractory Installed:
Locate and remove the two screws that secure the rear
refractory bracket in place. See Figure 2. Retain these
screws for later use.
SL-5, SL-7, SL-9, 350X-AU, 550X-AU:
Remove the two
screws adjacent to the air passage as shown in Figure 2.
CAUTION! Risk of Cuts or Abrasions.
Wear protective
gloves and safety glasses during installation.
NOTICE:
Handle refractory panels with care. Refractory
may chip or crack if dropped or impacted.
GLASS-5, GLASS-7, GLASS-9
GLASS-3X, GLASS-5X, GLASS-7X, GLASS-9X
Models: SL-5, SL-7, SL-9, SL-3X, SL-5X, SL-7X, SL-9X, 350X-AU, 550X-AU
Installation Instructions
CAUTION! Do not install damaged components.
DANGER
HOT GLASS
WILL
CAUSE BURNS.
DO NOT TOUCH
GLASS
UNTIL COOLED.
NEVER
ALLOW CHILDREN
TO TOUCH GLASS.
A barrier designed to reduce the risk of
burns from the hot viewing glass is provided
with this appliance and shall be installed for
the protection of children and other at-risk
individuals.
Figure 1. Metal Components - Components Shown Bent
UPPER GLASS BRACKETS
LOWER GLASS BRACKETS
REAR GLASS
BRACKET
NOTE: Install the lower glass bracket so the bend
clearance notch faces the front of the appliance.
BEND CLEARANCE NOTCH
Figure 2. Remove Screws that Secure Rear Bracket to Firebox
REMOVE SCREWS
