Heat & Glo • Escape-42DV • 2052-900 Rev. X • 3/11
48
F. Install the Log Assembly
If the gas logs have been factory
installed they should not need to
be positioned. If the logs have been
packaged separately, refer to the
following instructions.
NOTE:
If sooting occurs, the logs
may need to be repositioned slightly
to avoid excessive fl ame impinge-
ment.
Step 1.
NOTE:
If bulb and orange lens are
already installed, proceed to Step 2.
Remove the bulb from its packag-
ing and locate the sockets installed
in the square cut outs in the fi rebox
fl oor. The contacts on the bulb
push into the two small holes in the
socket top, as shown.
Place the framed orange lens on
top of the fi rebox fl oor covering the
bulb as shown. The four tabs on
the lens frame go into the square
cut out to help locate the lens.
CAUTION:
Logs are fragile!
Carefully remove the logs from the
packaging.
1
1
1
7
6
3
4
8
2 2
5
LOG PLACEMENT INSTRUCTIONS
Log Set Assembly: LOGS-ESCAPE42
Models: Escape-42DV
NOTE:
If logs rub against one an-
other during positioning, the white
inner material may become visible.
Touch-up paint may be applied to
the white areas using a small brush
or swab.
DO NOT
spray paint di-
rectly on surface of the logs. Refer-
ence service parts list for log touch-
up paint.
Î