Hearth & Home Technologies Inc. 800 W.
Jefferson, Lake City, MN 55041.
CRESTFIRE SERIES ELECTRIC FIREPLACE
10
10/03
4030-239 Rev G
H. FINAL INSTALLATION
Remove the protective cover to access final
installation items. Remove the hood, lava rock and
white rock from the inside of the appliance.
1. Attaching the Hood
Attach the hood by sliding the short flange into the
clips located above the upper panel. See Figure 8.
2. Remove the Log Assembly
The logs are attached to the grate by two zip-ties.
Carefully cut both ties using a utility knife or side
cutters. Discard the ties and packaging material. Lift
the log set straight up and place in a safe place. At
this time, the optional refractory can be installed into
the appliance. To install the refractory, refer to the
installation instructions supplied with the refractory
kit.
3. White Rock
Open the bag of white rock and spread it over the ember
bed glass and hearth pan. This will create the effect of
burning embers. Not all of the white rock needs to be
used. See Figure 9.
4. Lava Rock
Open the bag of lava rock (black) and spread it
sparingly on top of the white rock. This will create the
effect of an ash bed. Not all of the lava rock needs to
be used. See Figure 10.
5. Replace the Log Assembly
Set the logs back onto the grate assembly. Some of
the rock may have to be rearranged. This will allow
the logs to set correctly on the grate. See Figure 11.
Installation of other optional accessories may be done
at this time.
The appliance is now ready to operate. See Section
I. Operating Instructions.
Figure 8 - Attaching the Hood
Figure 9 - Placing White Rock
Figure 10 - Placing Lava Rock
Figure 11 - Replacing Log Assembly
Note:
When placing the white rock and lava rock,
you may want to periodically turn on the appliance
to check the appearance and customize to the
desired effect.
