2
Heat & Glo • LOGS-COSMO32, LOGS-COSMO42 Installation Instructions • 2491-932 Rev. D • 12/17
1
1
33
8. Install Log #1 by locating the back left tab behind the
burner. Place the log so that the left end is contact-
ing the tab and the front of the log is touching the back
sheet metal
fl
ange behind the burner. See Figure 4.
Figure 4. Place Log #1
LOG LOCATING TAB
LOG LOCATING TAB
Figure 5. Place Log #2 - Mineral Wool Placement
11.
COSMO42-IFT Only:
Install Log #3 by positioning front tip of log against
front lip of basepan with right side of log contacting
log tab. Swing rear tip of log back until it contacts
back wall of
fi
rebox. Log #3 will rest on Log #1. See
Figure 6.
SLR-X-AU Only:
Install Log #3 by resting it on top of Log#1. Log #3
will cross the burner and rest on the front lip of the
basepan. Right side of log will contact log tab. See
Figure 6.
Note:
When Log #3 is correctly positioned on Log
#1, the left side of both logs will line up vertically. See
Figure 7. (SLR-X-AU Only)
1
1
11
22
22
Figure 6. Place Log #3
10. Install mineral wool on burner. Mineral wool can be
placed the entire length of the burner, but it must only
be placed between the front row of ports and the space
in front of the burner. The mineral wool should not
cover any ports or fall so that it covers the gap behind
of the burner. See Figure 5
.
Figure 3. COSMO42-IFT Empty Base Pan
MINERAL WOOL
MINERAL WOOL
* LOG TAB
* LOG TAB
ROTATE LOG (COSMO42-IFT ONLY)
ROTATE LOG (COSMO42-IFT ONLY)
TAB
TAB
11
22
LOGS-COSMO42 (COSMO42-IFT / SLR-X-AU)
3
3
44
55
66
Figure 2. LOGS-COSMO42
NOTICE: To simplify the installation process, use
Figure 2 to positively identify each individual log before
beginning installation.
NO MEDIA ON BURNER OR IN GAPS
SCREWS
AIR TAB
LOG TABS (9)
SLR-X-AU
DO NOT BEND
PILOT
PILOT
SHIELD
SHIELD
9. COSMO42-IFT: Install Log #2 by placing the cutout
on the left side of the log over pilot shield and pull log
forward until it contacts the two log tabs. See Figure 5.
SLR-X-AU: Install Log #2 by placing the cutout on the
left side of log over the pilot shield. Pull log forward until
it contacts the rear basepan lip. Note that the tabs are
not used.
LOG TAB
LOG TAB
