Hearthstone Quality Home Heating Products, Inc.
Tucson DX/ST Model 8702
29
Heat Wave Baffle, Log Set, & Screen Placement
CAUTION: FRAGILE! HANDLE LOG SET WITH
CARE. ALWAYS WEAR GLOVES AND SAFETY
GOGGLES WHILE HANDLING THE LOG SET.
WARNING: Failure to position the parts in
accordance with these diagrams or failure to use
only parts specifically approved with this
appliance may result in property damage or
personal injury.
Place only the ceramic log set supplied with the unit
in the firebox. Do not place any other ceramic logs,
wood logs, or other materials in the firebox. If the
log set is damaged or broken contact your dealer for
replacement. The ceramic logs will last a long time;
however, they will break if subjected to rough or
improper handling. Exact positioning of the log set is
required in order to obtain a pleasing flame pattern
and efficient combustion. Incorrect log placement
may cause carbon build-up; excess thermal stress
on the log set and stove parts, reduced efficiency,
and high levels of carbon monoxide. If the log set
does not fit into the firebox exactly as outlined,
contact your dealer for assistance.
Installation of the Heat Wave Baffle
To install the heat wave baffle and log set, you must
have access to the firebox (for access instructions
see page 15).
1. Remove the Heat Wave baffle from the
packaging.
2. Set the base of the baffle centered on the shelf
in the rear of the firebox.
Photo 17 – Baffle Shelf
3. Lift the front edge of the baffle up to align with
the hole in the bottom of the cast iron heat
exchanger.
Photo 18 – Baffle Mounting Boss
4. Locate the mounting bolt and install it through
the baffle and into the boss on the heat
exchanger.
Photo 19 – Baffle Mounting Bolt
5. Do not over tighten the bolt as it may damage or
break the baffle. When installed properly, it
should look like the baffle in the following
photos. The bottom edge of the baffle must rest
on the shelf. If the baffle lifts off the shelf, the
mounting bolt is too tight.
6. You are now ready to open the restrictor plate
and install the log set.
Summary of Contents for Tucson 8702 DX
Page 2: ...Intentionally Blank ...
