HearthStone Quality Home Heating Products Inc
®
Model 8390
17
I
NSTALLING
I
N
A M
OBILE
H
OME
Follow these special requirements for installing
your stove in a mobile home.
Install the stove in accordance with 24 CFR,
Part 3280 (HUD) for US or CAN/ULC B 365
for Canada.
•
Permanently attach the stove to your mobile
home’s floor. Use the ¼-20 holes in each
leg base to bolt down the stove.
•
The outside Air Kit (90-53210) must be
used. (see page 10).
•
Install one of the following Dura-Vent
Mobile Home Chimney & Connector Kits:
6DP-MH 6” Diameter S/N 9096N
7DP-MH 7” Diameter S/N 9196N
8DP-MH 8” Diameter S/N 9296N
Each kit includes:
Stainless spark arrester cap, storm collar,
Adjustable vented flashing – 0/12 –
6/12, Two 24” Dura/Plus* chimney
pipes, 24” support box with built-in
starter section and trim.
•
(UL or ULC approved equipment is
acceptable)
•
Chimney must be removed when
transporting Mobile Home.
•
DO NOT operate with the door(s) open or
with Viewing Screen.
•
Use only with double-wall stove pipe.
▌
WARNING:
DO NOT INSTALL IN A SLEEPING ROOM.
USE OF NON-SPECIFIED COMPONENTS MAY
COMPROMISE THE SAFTY OF THE
INSTALLATION.
▌
CAUTION:
MAINTAIN THE STRUCTURAL INTEGRITY OF
THE MOBILE HOME
WALLS, FLOOR,
CEILING, AND ROOF WHILE YOUR STOVE IS
INSTALLED AND IN USE
.
Chimney Section
Chimney Cap
Stovepipe
Chimney is supported by Ceiling.
Typical Mobile Home Installation.
Storm Collar
Adjustable Roof
Flashing
Support Box
with built-in
Starter section
