Hearthstone Quality Home Heating Products, Inc.
Manchester Model 8330 Pellet Stove
Page 13 of 59
Installation
Room Sensor Installation
We recommend you install your Manchester Pellet stove with the provided room sensor for optimum efficiency
and comfort. The room sensor is a wired remote temperature probe for the stove’s electronic control system.
With the room sensor, the control system can efficiently regulate the stove’s rate of burn to keep a more
consistent room temperature and level of comfort. The room sensor gives you the option to use the Automatic
and Programmable modes of operation (See Page 28).
1. Locate the room sensor as you would a regular thermostat. Do not install near the stove. Avoid other
sources of heat such as sunny walls, and appliances such as televisions or refrigerators. Avoid placing
near, or in unusually cool areas such as windows, entry areas, or on exterior walls.
2. Install the sensor’s wiring carefully – if concealing the wiring, ensure it is properly secured and protected
from future damage.
3. Once the room sensor and wiring are properly installed, connect the sensor’s wiring to the 15 pin
connector on the back of the unit.
Optional Thermostat Installation
You can purchase your own thermostat for use with the Manchester Pellet stove. Ensure the thermostat is
properly located and the wiring properly installed to maximize the efficiency of the unit. Any UL approved milli-
volt thermostat will operate this stove. In Thermostat Mode, the thermostat will turn the stove on and off, but will
not automatically vary the rate of burn. You must regulate the rate of burn manually.
Due to the complexity of the startup / shutdown process it will take approximately 10 minutes for the pellet stove
to respond to any signal from the thermostat. We recommend operating the stove only with the provided room
sensor to minimize this start / stop cycle.
1. Locate the thermostat connection (see image above), and remove the connector from the stove.
2. Use a small flat tip screwdriver – loosen the screws and remove the shunt.
Note:
do not connect the Room Sensor if using a thermostat.
Room Sensor Connection
Thermostat Connection
Shunt
Thermostat Wire
