02-02
11
30344 Rev C
NOVI30 AND NOVI35
2.
Remove and retain the four attachment screws at the corners of the face of the appliance.
3.
Disconnect the ON/OFF switch from the low voltage wire leads. Pull the wires through the surround and trim. Attach
the wires to the ON/OFF rocker switch. Push the rocker switch into the hole. See Figures 13 and 14.
4.
Slide the surround against the face of the appliance, aligning the holes in the upper and lower, right and left corners
and secure the surround to the appliance with the attachment screws. See Figure 15. If optional surround bottom
is used, go to Step 5. If surround bottom is not used, slide the appliance back until the surround is tight to the
fireplace. Route power cord away from the appliance.
5.
Optional Surround Bottom. Remove the surround bottom from the carton. Place hooks on the surround bottom
through the slots on the bottom of the surround side. See Figure 16. Slide the surround bottom to the left. Slide the
surround back until the it is tight to the appliance. Route power cord away from the appliance.
6.
Installing Upper Grille and Control Access Panel. To install the upper grille, place the upper slot on the bracket over
the upper screw. Rotate the grille downward. See Figure 17.
To install the control access panel, place the stationary pin (located on the right hand side of the grille) into the
lower slot on the surround. Pulling back the spring hinge (located on the left hand side of the grille), slide the grille
until the spring hinge lines up with the lower slot on the surround. See Figure 18. Let the spring hinge engage the
slot. Rotate the lower grille up and over the screw on the surround.
Figure 13
Attach ON/OFF Rocker Switch
Wires
Figure 14
ON/OFF Rocker Switch
Figure 15
Attaching Surround
Figure 16
Optional Surround Bottom
Figure 17
Installing the Upper Grille
Figure 18
Installing the Control Access
Panel
All manuals and user guides at all-guides.com
all-guides.com
