Hearth & Home Technologies • RC300 Multifunction Remote Control • 2166-393 Rev. C • 9/10
6
About ON Mode
• All functions can be accessed when the remote control
is in the ON mode.
• Only active functions will be displayed when the remote
control is in the ON mode. For example: if the fan is the
only function that’s active, the fan icon and fl ame will be
the only icon shown in the display.
About OFF Mode
Only the following functions can be accessed in the OFF
mode:
• AUX1
• AUX2
• Constant Pilot
Only active functions will be displayed when the remote
control is in the OFF mode.
Turning On the Fireplace
• Press the POWER button to turn the fi replace ON. The
fi replace will fi rst ignite the pilot. Once the pilot fl ame is
established the main burner will be lit.
NOTICE: Whenever the fi replace is cycled from OFF to
ON, the main burner will light on high for 10 seconds before
returning to the previous user setting.
Adjusting Flame Height
• Press the
MENU
button to activate the menu.
• Using the
UP
and
DOWN
arrows highlight the
FLAME
icon and press
SELECT
.
• Use the
UP
and
DOWN
arrows to adjust the
FLAME
HEIGHT
, then press
SELECT
. The
FLAME HEIGHT
can be adjusted to 5 different settings.
NOTICE: FLAME HEIGHT will not be adjustable for fi rst
ten seconds when fi replace is turned on.
NOTICE: The system will remember the previous FLAME
HEIGHT setting and will automatically adjust after 10
seconds.
Adjusting Fan Speed
• Press the
MENU
button to activate the menu.
• Using the
UP
and
DOWN
arrows highlight the
FAN
icon
and press
SELECT
.
• Use the
UP
and
DOWN
arrows to adjust the
FAN SPEED
,
then press
SELECT
. The
FAN SPEED
can be adjusted
to 3 different settings: HIGH, MEDIUM, LOW.
NOTICE: The fan has a timer built into the control module.
After the fi replace is turned ON the timer will wait for 7
minutes before turning on the fan. In addition, the fan
will remain on for 12 minutes after the fi replace has been
turned OFF.
NOTICE: Whenever the fan is turned ON, the FAN will start
up on the high setting for 10 seconds before adjusting to
the previous user setting.
AUX1 Function (Unit dependent Function)
• Press the
MENU
button to activate the menu.
• Using the
UP
and
DOWN
arrows highlight the
AUX1
icon
and press
SELECT
.
• Use the
UP
and
DOWN
arrows to adjust the
AUX1
output,
then press
SELECT
. The
AUX1
function
can be adjusted
to 4 different settings: HI, MED, LOW and OFF.
AUX2 Function (Unit dependent Function)
• Press the
MENU
button to activate the menu.
• Using the
UP
and
DOWN
arrows highlight the
AUX2
icon
and press
SELECT
.
• Use the
UP
and
DOWN
arrows to turn the
AUX2
ON
or
OFF
, then press
SELECT
. The
AUX2
function
can be
either be turned
ON
or
OFF
.
NOTICE: The system will remember the previous AUX1
and AUX2 setting from the menu. However, when the fi re-
place is turned OFF both AUX1 and AUX2 will be turned
off. AUX and AUX2 can be activated when the fl ame is off
from the remote’s OFF mode. When the fi replace is turned
back ON the AUX1 and AUX2 settings will be restored to
the previous ON setting.
