1
Hearth & Home Technologies • Wi-Fi Module Installation Instructions & User Guide • 2326-984 Rev. C • 7/20
Leave this manual with party responsible for use
and operation.
IntelliFire
®
Wi-Fi Module (IFT-WFM)
Installation Instructions
1. Introduction
The IntelliFire Wi-Fi Module (IFT-WFM) is designed to
allow the communication between the Hearth & Home
Technologies appliance and an Android or iOS device.
The IntelliFire app allows the ability to control many
of the available features on the appliance. Also the
IntelliFire skill on Amazon Alexa or Google Assistant
allows you to turn on and off your appliance.
Note:
The IntelliFire Wi-Fi module supports 2.4GHz or
2.4GHz / 5GHz dual band Wi-Fi networks only. To check
your network frequency, refer to your wireless router
manual or contact your internet service provider.
2. Wi-Fi Module (IFT-WFM) Installation
A. Precautions / Preparation
This device is tested and safe when installed in accor-
dance with this installation manual. Do not install any
components that may be damaged.
Do not modify, disassemble, or substitute any of the com-
ponents included with this kit. Installation of this kit must
be done by a qualified service technician.
For best performance, the location of the IntelliFire IFT-
WFM to the Wi-Fi router or your network extender should
be less than 50 feet from the appliance.
Hearth & Home Technologies disclaims any responsibility
for, and the warranty will be voided by, the following actions:
• Installation and use of any damaged system component.
• Modification of the system component.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
Any such action may cause a fire hazard.
• Read, understand and follow these instructions for safe
installation and operation.
B. Kit Contents
• Wi-Fi Module (IFT-WFM)
C. Installation Steps
CAUTION! Do not install damaged components.
If you
received components that are damaged, contact your
dealer for assistance.
1. Write the IFT-WFM Wi-Fi SSN# on top of the User
Guide. If you have multiple appliances to set up,
write the appliance description / location associated
with the IFT-WFM Wi-Fi SSN#. See Figure 1.
Figure 1 IFT-WFM Wi-Fi SSN # Location
IFT-WFM
Wi-Fi
SSN #
2. Locate the IntelliFire Touch electronic control module
(IFT-ECM) in the control cavity of the appliance and
move the selector switch to the OFF position. See
Figure 3.
NOTICE:
IFT-ECM must have Wi-Fi sticker adhered to
it. If the IFT-ECM does not have the sticker, you must
replace it with one that does. See Figure 2.
Figure 2 Wi-Fi Label
Wi-Fi LABEL
RUBBER COVER
