Hear and Learn UConnect Flexmike, Installation And Troubleshooting Instructions

Page: 3 / 3

hearandlearn.com.au
UConnect SoundHouse & Mini, 975 Point to Pair, Redcat Point to Pair & Topcat Point to Pair are part of the Hear and Learn technology family.
Offices Australia wide (03)93709355
3/3
DAILY USE OF THE SHAREMIKE
At the start of the day, remove Sharemike
from the charger
Ensure the 975 is on. The white power light will glow.
Turn on the Sharemike by pressing and holding the
power button until the LED lights.
Grip the barrel in the center section.
While speaking in a normal voice, increase the volume
with the Sharemike until your voice is barely audible.
Power button Power light
Status light
975
975
Back Front
RedCat
Flexmike
Power
Power
Mic 1
Mic 1
Mic 2
Mic 2
IR Transmitter
IR Transmitter
Sharemike
TopCat
Power
button
Volume
controls
PAIRING YOUR MICROPHONE TO 975, REDCAT OR TOPCAT
PAIRING THREE MICROPHONES HELP VIDEO
From a powered off state, point the IR
transmitter lens toward the IR sensor
(marked with red rings on illustrations
below) on the 975, RedCat or TopCat
(for Sharemike, the transmitter lens is
located on the back of the microphone).
Press and hold the power button for 5
seconds until the mic 1 and mic 2 lights
start flashing, then release the button
and let the pairing process finish.
The ”status” light on 975, RedCat and
TopCat will light up indicating the pair-
ing process is complete. The mic 1 or
mic 2 light on the microphone will stay
illuminated.
Your system is shipped with microphones and base units pre-paired for quick and easy use. If, for any reason, you need to pair new components, follow this pairing process:
IR transmitters on microphones &
IR sensors on 975, RedCat & TopCat
(marked with red ring)
REPLACING BATTERIES IN FLEXMIKE & SHAREMIKE
(Battery part #L3.7V)
FLEXMIKE
1. Push down on the latch
and carefully pull the battery
pack away from the
Flexmike.
2. Insert new battery pack as
shown and make sure the
latch is secure.
3. Place the Flexmike in a
cradle charger to charge
the battery pack.
SHAREMIKE
1. Push down on the latch
and carefully pull the battery
pack away from the
Sharemike.
2. Insert new battery pack as
shown and make sure the
latch is secure.
3. Place the Flexmike in a
cradle charger to charge
the battery pack.
1
1 2 3
2
3
4
Click on the image to watch the help video
Set up installation and troubleshooting instructions
for Flexmike and Sharemike
hearandlearn.com.au
USHMHG0522
©Hear and Learn®