6
Figure 9. Step 2
Figure 10. Step 3
5.
Optional Coconut Shell Carbon Canister
a. Remove old carbon canister (if installed) by pulling it
out from the inside of the HEPA filter.
b.
If replacing an inner charcoal filter with the carbon
canister, remove inner charcoal filter by following
the steps a. to c. in section 3.
c. Remove the plastic shrink wrap from the new carbon
canister.
d. Slide the carbon canister into the HEPA cartridge,
smaller, tapered end first. The carbon canister
should slide all the way in until the metal edges at
the base meet the HEPA filter.
e.
Support the carbon canister with your fingers
so it does not slide out when replacing the HEPA
cartridge assembly into the unit.
6.
Installing the HEPA Filter Cartridge
a.
With the filters changed or inspected, all 3 filters
are ready to be placed back into the unit. Place
the HEPA cartridge gently into the unit (if a carbon
canister is being used, take care not to let it slide out
as it is heavy and could damage the unit)
b. When the HEPA cartridge is in place, brace the unit,
press down and turn it clockwise to lock it into place.
c.
Replace the HEPA filter access panel and latch it
with the four retaining clips.
d.
Re-install safety screws into HEPA filter access
panel.
e. Plug the unit back into a power outlet and turn it on.
Dealer Motor Assembly Replacement
Instructions
1.
Accessing the motor assembly
a.
Turn the unit off and unplug it from any electrical
source before opening the cabinet.
b. To remove the motor section access panel, remove
the four screws on the panel, and lift off panel.
2.
Removing the old motor assembly
a. Disconnect all four motor wires from switch, ground
post and capacitor.
b. Disconnect the two white wires from the capacitor.
c. Separate the motor from the motor mount by
removing the four screws found in figure 16.
d. Slide the motor out from under the motor mount
to remove it from the unit.
3.
Installing the new motor assembly
a. Slide the new motor into the motor mount making
sure that the wires go through the smaller hole
offset from the center of the bracket.
b. Secure the new motor to the motor mount with the
four screws removed in step 2c.
c. Connect the wires as follows:
»
Blue wire from motor to the on/off switch.
»
Yellow/green wire from motor to the ground post.
»
Brown wire from the motor to a capacitor post.
»
Black wire from the motor to the other capacitor
post.
»
White wire from the on/off switch to the capacitor
via the black wire piggyback post.
»
White wire from the power cord to the capacitor
via the other white wire’s piggyback post.
4.
Closing the unit
a. Replace the motor section access panel and
secure it with the eight screws removed in step 1b.
b.
Plug the unit into it’s electrical source and turn it on.
Figure 11. Closing the Unit
