6
2
75
1
72
28
56
1. Attach the Front Stabilizer (2) to the front of the
Frame (1) with two M8 x 70mm Carriage Bolts (72),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56).
Make sure that the Front Stabilizer
is turned so the Roller (75) is not touching the
floor.
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M8 x 80mm Carriage Bolts (63),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56).
3. While a second person holds the Upright (6) near
the Frame (1), route the Resistance Cable (67) up
through the Upright and out of the indicated hole.
Next, connect the Extension Wire (18) to the Reed
Switch Wire (44).
Carefully slide the Upright (6) onto the Frame (1).
Be careful to avoid pinching the wires.
Attach the
Upright with four M8 x 15mm Button Screws (74)
and four M8 Black Flat Washers (57).
Next, connect the short cable on the Resistance
Control (8) to the Resistance Cable (67) in the fol-
lowing way:
¥ Refer to drawing A. Insert the tip of the short cable
into the wire clip on the Resistance Cable (67) as
shown.
¥ Refer to drawings B and C. Firmly pull the short
cable and slide it into the metal bracket as shown.
Push any excess Resistance Cable (67) into the
Upright (6). Attach the Resistance Control (8) to the
Upright with an M5 x 15mm Screw (69).
2
3
63
3
6
67
74
74
57
57
69
44
1
18
57
57
28
28
56
56
1
1
Short
Cable
Metal
Bracket
8
67
A
B
C
