23
PROBLEM
SOLUTION
a.
If the walking belt has shifted to the
left,
first remove the key and
UNPLUG
THE POWER CORD
. Using the allen
wrench, turn the left rear roller adjustment
bolt clockwise, and the right bolt counter-
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in
the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
b.
If the walking belt has shifted to the
right,
first remove the key and
UNPLUG
THE POWER CORD
. Using the allen
wrench, turn the left rear roller adjustment
bolt counterclockwise, and the right bolt
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in
the power cord, insert the key and run the
treadmill for a few minutes. Repeat until the walking belt is centered.
c.
If the walking belt slips when walked
on,
first remove the key and
UNPLUG
THE POWER CORD
. Using the allen
wrench, turn both rear roller adjustment
bolts clockwise, 1/4 of a turn. When the
walking belt is correctly tightened, you
should be able to lift
the edges
of the
walking belt 3 to 4 inches off the walking
platform. Be careful to keep the walking belt centered. Plug in the power cord, in-
sert the key and run the treadmill for a few minutes. Repeat until the walking belt
is properly tightened.
a. Remove the key from the console and
UN-
PLUG THE POWER CORD.
Next, remove
the screws from the hood and carefully re-
move the hood. Locate the Reed Switch
(26) and the Magnet (85) on the left side of
the Pulley (28). Turn the Pulley until the
Magnet is aligned with the Reed Switch.
Make sure that the gap between the
Magnet and the Reed Switch is about
1/8Ó.
If necessary, loosen the Reed Switch
Screw (2) and move the Reed Switch slightly. Retighten the Screw. Re-attach the
hood, and run the treadmill for a few minutes to check for a correct speed reading.
a
b
c
4. The walking belt is
off-center or slips
when walked on
5. The displays of the
console do not func-
tion properly
85
26
2
Top
View
1/8Ó
28
