MM-T01 User Manual [rev. 004] | www.healtech-electronics.com/MM
2/2
5.
Operation
6.
Cleaning and storing the unit
- If the speedometer is set to MPH reading, change
the indication in the dash menu from MPH to Km/h.
- Locate the BLACK, 16-pole diagnostic connector
(usually it’s under the rider’s seat in a black
rubber boot).
- Connect the MM unit.
- Make sure the engine stop switch is in the RUN
position, the ignition key is switched ON and the
gearbox is in Neutral. Do NOT start the engine.
- Now a number (0-20) should appear on the
display of the unit, depending on the last
successful upload. Otherwise, check that the
connectors are fully mated and there are no bent
terminals.
- The service interval can be set between
0-20,000 km.
Clean the unit with a wet sponge. Use water only, without any detergents. Do not clean with a dry cloth
as it may scratch the front face.
Changing the value
With the UP and DOWN arrow symbols select the desired value between 0 and 20,000 km.
Tap and release one of the touch pads. The number changes when you release the pad.
Holding the pad continuously will not alter the value.
Setting the service interval
Touch and hold both the UP and DOWN arrow keys. After about 4 seconds the ‘
UP
’ sign will flash a few
times on the display, indicating the upload was successful. Release the touch pads.
If the upload fails, an ‘
Er
’ (Error) sign will appear. Check that this motorcycle actually has a service
interval indicator. If so, repeat the steps described in chapter 5 and try setting a lower service interval.
Note:
- If you perform the upload more than once, only the last uploaded interval will be set.
- If you attempt to set a value higher than valid for a particular motorcycle, the highest valid value will
be set. Please refer to the bike’s Service Manual.
Verifying the stored service interval
- Turn the ignition key off, wait at least 5 seconds then turn on again. Make sure the engine stop switch is
in the RUN position and the gearbox is in Neutral.
- Scroll through the menu of the bike’s instrument panel to the distance to service and check the value.
- If the desired value is shown, disconnect the MM tool. Otherwise, repeat the process.
- If the speedometer was in MPH reading prior to the procedure, change the indication in the dash menu
back from Km/h to MPH.
Displayed values and their meanings
The service interval is set to 0 and
the small wrench symbol lights up.
Sets 100, 200, 300, … 900
Sets 1,000, 2,000, 3,000, … 9,000
Sets 10,000, 11,000, 12,000, …
20,000
Error - setting the service interval
failed.
Upload - the selected service
interval was uploaded successfully.
