HE-VA Combi-Disc, Operating Instructions Manual

Page: 18 / 56

Combi-Disc 01/08 -2015
21
Replacement of wearing point
Before working with the machine’s wearing points, the machine is to be
fastened. This can be performed by trestles under the main frame or by a
support of the roller.
The wearing point might fall off, when the bolt is removed – take care to avoid
foot and leg injuries.
1. Dismount M16x65 mm bolt (Pos. 1) by means of 2 pcs. 24 mm spanners.
2. The wearing point might fall off, when the bolt is removed – take care to avoid foot
and leg injuries.
3. Dismount the wearing point by pushing it forward. This might be difficult due to entrance of
soil, and it might be a good idea to use a hammer.
4. Mount the new standard wearing point, item no. 645000044 (Pos. 2) by pushing the wearing
point to the rear and then in its place.
5. Check the M16 x 65 mm bolt for eventual damages and replace it as required, item no.
690 690113008.
6. Mount the M16 x 65 mm bolt (Pos. 1), lubricate and tighten it with 20 Nm. Be careful not to
tighten too much – as the wearing point might be damaged.
1
2