lock and the light continues to operate as if the lock had never
been set. Rapidly click 3 times when off to set the temporary
lock and leave the light on with the selected brightness level.
Low Battery Indication
Your flashlight will turn off momentarily and then back on one
level below the previous brightness level when the battery is
unable to supply enough power to run the current brightness
level. This process is repeated as needed as the battery’s
power is depleted.
Your flashlight will double-blink once every two minutes to
remind you that the battery needs to be changed when the
battery is no longer capable of maintaining a 50 lumen output
level and you are asking for an output lever higher than the
battery can maintain.
Your flashlight restricts the output to the highest brightness level
the battery can maintain. However, if you turn off your flashlight
and turn it back on again to a higher level, your flashlight will
slowly step up through the brightness levels testing the battery
again.
Disabling the Switch
The switch can be disabled by unscrewing the battery
compartment from the head one half turn. This will leave the O-
ring completely covered.
You restore operation of the switch by screwing the battery
compartment completely into the head.
Cleaning and Maintenance
Periodically clean the open end of the battery compartment, the
battery compartment threads and O-ring with a clean lint-free
cloth lightly moistened with isopropyl alcohol. Apply a coat of
non-conductive silicon or petroleum grease to these surfaces.
Replace the battery compartment O-ring if it becomes worn or
damaged. O-ring: 1.5mm x 20.5mm, 70 durometer Nitrile
(Buna-N).
The recessed electrical contacts and interior threads in the head
can be cleaned using a lint-free swab lightly moistened with
isopropyl alcohol. Recessed contacts and threads should be
cleaned in a counter-clockwise direction to prevent snagging the
swab in the threads. Be sure to remove any particles or fibers
that may be left behind. Apply a coat of non-conductive silicon
or petroleum grease to the interior threads and contacts.
The exterior can be cleaned with a mild soap and water. Rinse
well and dry with a soft cotton cloth.
Note:
the anti-reflective coating on the lens can be abraded by
excessive rubbing or cleaning. Never use paper tissues or
paper towels to clean or dry the lens as the fibers are abrasive.
Additional Information
Please view EDC Tactical Advanced User's Guide on our web
site for a complete coverage of all features.
Warranty
Please view the full warranty on our web site.
Updated January 1, 2015
Specifications subject to change without notice.
HDS Systems, Inc.
Phone: 520-325-3004
P.O. Box 42767
E-mail: [email protected]
Tucson, Arizona 85733 USA Web: www.HDSsystems.com