A
B
STEP 4
Place the device on top
of the work surface
Please make sure all equipment is installed in
line with the edge of the workstation or it may
cause injury or damage to the product.
ATTENTION!
To operate the workstation, press the
handle and raise or lower the top to
the desired height.
Move the adjustment block to adjust
the keyboard tray angle
Please note: The work surface should be bigger than the
base of this product to prevent damage or personal
injury while adjusting product height.
NOTE!
The stickers can be removed by clean water.
Attach the sticker to the
bottom of the monitor
Sticker B
Sticker A
Sticker B can be cut to size
WARNING!
PINCH POINT
Do not place your hands near the strut.
The strut’s angle will change during height adjustment
causing a pinch point which may cause injury.
ATTENTION!
Please make sure all equipment is installed in line
with the edge of the workstation or it may cause
injury or damage to the product.
ATTENTION!
Cables
Leave enough cable length for height adjustment
to avoid unexpected damage due to falling items.
Press
WARNING!
Press the grips while gently pressing down on the
workstation to adjust the height.
Only adjust the height when the item on the
workstation is less than 3Kg to prevent bouncing
which could cause property damage or personal
injury.
CAUTION
This product contains small items that could be a choking hazard if swallowed.Keep these items away from young children.
●
Make Sure these instructions are read and completely understood before attempting installation.If you are unsure of any part of this installation,please contact a professional
installer for assistance.
●
The desk or mounting surface must be capable of supporting the combined weight of the mount and the display,otherwise the structure must be reinforced.
●
Safety gear and proper tools must be used. A minimum of two people are required for this installation. Failure to use safety gear can result in property damage, serious injury or
death.
●
Please check joint parts every two months, making sure the screws are tight.
This product was designed to be installed on desk. Before installing, make sure the mount will support the combined load of the equipment and
hardware. Never exceed the maximum load capacity 9 KG, or else it may result in product failure or personal injury.
Note: this product is intended for indoor use only. Use of this product outdoors could lead to product failure or personal injury.
.
Warning:
obsolete products can be sent back to the manufacturer or handed over to professional institutions.
To ensure the sealing performance of the gas spring, it is suggested to have complete adjustment to the upper arm (with spring) once or twice a month.
This product contains high pressure gas spring parts, please do not put it into fire, high temperature, or disassemble it, which will lead to unexpected
personal injury. The
2 of 2
October 3, 2017
REV C
Heartwood Distributors Ltd
Heartwood Manufacturing Ltd
QUESTIONS OR CONCERNS?
PHONE Customer Service
1-800-567-3060
M-F 6am - 4:30 pm PST
www.heartwood.ca
Use the cable to clip
7
www.heartwooddl.com