13
This section aims to verify that your XTND’s IR control system is setup correctly and assumes that all other setup has been followed as per
the instructions laid out in this manual. Please refer to the XTND wiring diagrams in this document to ensure that your setup matches that
before proceeding with the verification below.
Testing operation from a display ‘back’ to the XTND transmitter
Start this test by ensuring that your XTND system is powered on and your source device (connected to your XTND transmitter) is being
correctly displayed on screen. Check that your IR cabling is correctly connected to your XTND system (page 12) and that your remote control
has a clear line-of-sight to the IR RX. Point your remote at the IR RX and test a remote control command for your source device. You should
notice that it responds as if the source device was directly in front of you. If it worked then you have setup IR control correctly. Repeat this
step at the XTND transmitter end to confirm control over displays.
Testing that IR works