MHUB 4K (4x4) Manual
9
OPERATING YOUR SYSTEM
MANUAL OPERATION
You can switch between sources manually by using the buttons on the front of the central hub. First press one
of the four output buttons for the required output to be changed. Next select which input is to be routed to
that output by pressing one of the input buttons. There are two additional buttons labelled ‘ALL’ and ‘PTP’. If
you press the ‘ALL’ button then select an input, this will change all outputs to the selected input (i.e pressing ALL
then Input1 will set all outputs to Input1). Pressing the PTP button will match all outputs to all inputs ( Output1
to Input1, Output2 to Input2, Output3 to Input3 etc).
REMOTE OPERATION
The small remote control shown below is included with MHUB. This can
operate the system from directly in front of the matrix, via the IR receiver
window on the front of the matrix and also via the IR RX cables connected to
TV Receivers.
INTEGRATING WITH A CONTROL
SYSTEM VIA IP OR RS232 PORT
For more information visit:
http://support.hdconnectivity.com/2015/08/MHUB-2K-control-system-integration
