3 of 4
•
Dust gently using a soft cloth or fabric duster.
•
Do NOT use any chemicals or solvents to clean.
•
Handle the light sets gently. Do NOT pull or tug light sets as this may inadvertently loosen the bulb.
•
Follow all Storage and Safety Instructions.
STORAGE
1.
Remove any ornaments and decorations that were added by you and did not come with the tree.
2.
Unplug the tree from the power source in your home and disconnect the plug connection between each tree
section.
3.
Starting with the top, separate each tree section and stand gently, being sure not to roughly handle as it could
cause damage to the parts. TIP: If there is difficulty separating the tree sections, apply a small amount of
lubricant where the poles join.
4.
Compress each tree section by turning it upside down and squeezing the branches together so that it will fit
more easily into the storage box or container. You can also tie a ribbon or cord around the sections to secure
the branches closer together for storage.
5.
Place all the parts gently back into the storage box. The box will help prevent the tree from being damaged
should it get bumped in your garage, basement, or other storage location. Tape the box shut to keep out any
dust or insects. When packing up the tree, please ensure that there is no undue strain or stress on the light sets
to ensure they do not get cut, frayed, or damaged.
6.
Be sure to store the tree in a cool, dry area free of water and moisture to prevent mold and mildew from
accumulating and a musty odor developing. Exposing your tree to excessive heat or humidity may damage your
tree. DO NOT STORE TREE IN A DAMP AREA OR IN AN AREA WHERE THE TEMPERATURE EXCEEDS 100ºF. STORE
THE CARTON FLAT AND
NOT
UPRIGHT ON ITS SHORT END.
TROUBLESHOOTING
GUIDE
FOR
LIGHTS
If your lights are not working, following are some troubleshooting steps to try:
1.
Check that the power plug is properly connected to your wall outlet or other power source and tap the foot pedal.
2.
Check that there is power to the wall outlet or power source.
3.
Check that all the plugs within the tree are securely connected and positioned correctly. Plugs are keyed to fit one
direction only with the flat section of the female plug matching up to the flat section of the male plug.
NOTE: LED bulbs are permanent and cannot be removed from the light sets.
IMPORTANT
SAFETY
PLEASE READ AND FOLLOW ALL SAFETY INSTRUCTIONS AND WARNING TAGS INCLUDED WITH THIS TREE.
SAVE FOR FUTURE USE. THIS TREE IS SAFE FOR INDOOR USE ONLY.
•
Do not operate this product if the power cord or plug is damaged. Always inspect light sets and electrical cords for
signs of damage or wear. If there are any observable defects, immediately dispose of them and replace it with one
that is in working order.
• Do not immerse the tree or any of its components in water or other liquids.
• Be careful not to overload electrical circuits and do not string more than the manufactured recommended number
of light set cords together.
• This seasonal use product is not intended for permanent installation or use.
• This product is not intended for commercial purposes.
• Do not secure the wiring of this product with staples or nails or place on sharp hooks or nails.
Female Plug Flat Section
Male Plug Flat Section
