Assembly - Belt mount at thighs
Remove the seat cushion and the armrests. Note that the pictures show the right-hand side.
Remove the screws and washers from the armrest mount.
Put the spacers and rail in place. Fasten with the included screws.
Note
: Check carefully that the correct rail is used on the correct side.
Push in the mount at the desired position and turn to secure it in place.
Repeat these steps on the opposite side.
Use and Care instructions
Always replace damaged parts immediately. For more information see
Maintenance Instructions
,
document number 96730-1.
- There may be local restrictions on use of belts.
- Individual information about the use of a belt must be received from the prescriber for each user.
- Be alert when using of positioning belt or harness. There is a risk of the user sliding down in the
chair and getting stuck in the belt if it is incorrectly installed or poorly fastened. This can lead to
impaired blood or oxygen supply and risk of the user choking.
- Always make sure that the belt is securely fastened when in use.
- If possible, tighten the belt with the user in an upright position. If the belt is tightened when the
back is reclined there is a risk of pinching when the back is raised up.
- Be aware of loose belts, they can get caught in the wheels and cause a sudden stop or pinching.
- A harness is always used in combination with a positioning belt.
User Manual/Assembly Instructions - Belt mounting kit
Page 2 (2)
2
3
1
1
2
3
4