Rev. A
Page 1 (1)
User manual /
Assembly instructions
Heel loops, HD Balance
Art.no. 95817-1
Art. no.: 62995-1
MANUFACTURER: Hantverksdesign & Rehabiliteringsprodukter AB
Tryffelslingan 4, SE-181 57 Lidingö, Sweden
tel. +46 8 767 04 80
fax. +46 8 767 50 00
www.hdrehab.se [email protected]
Latest revision: 2012-05-10
Parts included:
Assembling
The heel loops are mounted in the rear holes of the foot plate.
Use and Care instructions
The heel loops shall be cleaned by wiping with soap and water. For further information, see the
Maintenance Instructions, art. no. 95730-1.
After a long period of use the screws should be checked on, to see if they need to be tightened.
Diagram 2.
Finished!
Diagram 1.
Assemble the screws, washers, tubes, heel
loops, foot plate and nuts according to the figure. Use an
Allen key (5 mm). Tighten the screws securely.
- The product should not be used by spastic users or users with a similar pattern of movement/
behavior. These persons can hurt themselves if kicking the fastenings (the screws and tubes).
- Don't let the user sit with their feet resting against the fastenings (the screws and tubes) for
long periods, as there is a risk that this can cause harmful pressure.
!
4 x
2 x
